Sizing Guide · What Size Generator Do I Need?

What size generator do I need for a Houston home?

Square footage alone does not size a generator — your loads do. This guide shows the size bands Houston homes actually land in, how starting watts and AC surge change the answer, and how to check your own total before an installer gives you a number.

Size by home and what you need running

Use this as a planning starting point. Your final size should come from a load calculation that lists each circuit you want powered during an outage.

Home & goalTypical sizeWhat it usually covers
Small home / essentials only10–14 kWRefrigerator, lights, electronics, furnace blower, microwave, and selected outlets. Central AC is usually left off, managed carefully, or handled with a soft-start approach confirmed by the installer.
Typical home, 2,000–2,500 sq ft, with AC16–22 kWOne central AC unit plus essentials, kitchen basics, laundry used one load at a time, and a pool pump or sump pump in many cases. This is the most common Houston band.
Large home / full load24–26 kW+Two AC units or one large unit, electric range or dryer, second refrigerator or freezer, pool equipment, and more circuits running together without strict load management.

Ranges are planning estimates based on typical Houston loads, November 2026. They are not quotes and do not replace a formal load calculation for your home.

Run your numbers before the sales visit

Our free load calculator is the sizing tool for this guide: check the appliances you need in an outage and it totals the running watts and shows the size band that fits at the 80% rule. Bring that printout to every quote conversation. If an installer's recommended size differs from your worked total, ask them to show the load list behind their number — in writing, alongside the itemized pricing in our whole-house cost guide.

How load calculation works

A proper calculation adds running watts, allows headroom, and accounts for the largest motor surge. Skipping any of those steps is how homes end up undersized for AC or oversized for loads they never run together.

Part of the calculationWhat it meansWhy it matters in Houston
Running wattsContinuous drawThe steady total of everything on at once — AC running, refrigerator, lights, pumps, and electronics. Your generator should carry this at roughly 80% of its rating, not at its maximum.
Starting watts / surge2–3× running, brieflyMotors draw a short surge at startup. A central AC unit is usually the largest surge in the home, and it can coincide with other loads already running.
AC tonnage3 ton ≈ 3,500 W · 5 ton ≈ 5,800 W runningCooling is the deciding load in a Houston outage. One unit versus two, and 3 ton versus 5 ton, moves the recommended band more than square footage does.
Load managementPauses heavy loads in turnModules keep the dryer, range, second AC, or EV charger from stacking at the same moment — often the difference between a 22kW and a 26kW+ recommendation.

What moves your price up or down

Keeps cost down

Sizing to essentials plus one AC instead of every circuit · load management instead of the next size up · leaving EV charging and electric drying out of the outage plan · confirming the size with a written load calculation before comparing quotes.

Pushes cost up

Moving from the 16–22kW band to 24–26kW+ · two AC units running together · electric range, dryer, water heater, and hot tub all included · liquid-cooled units for larger loads · a size chosen with no load list to support it.

For context, whole-house standby systems in Houston are quoted across a $9,000–$25,000 installed range overall. Size is one driver of where you land in that range — gas and electrical scope are the others. Compare installers on the same size and scope using the installer comparison table.

Generator sizing questions, answered

What size generator do I need for a 2,000 square foot house in Houston?

Most 2,000–2,500 sq ft Houston homes that want one central AC unit plus the essentials land in the 16–22kW band. The exact size depends less on square footage than on what runs at the same time: one 4-ton AC, refrigerator, lights, and kitchen basics fit very differently than the same home with an electric range, electric dryer, and a second AC unit. Use the free load calculator on this site for a worked total, then have an installer confirm it with a formal load calculation.

What is the difference between starting watts and running watts?

Running watts are what an appliance draws continuously. Starting watts are the brief surge a motor draws for a few seconds when it starts — often 2–3 times its running draw. Central AC is the largest example in most Houston homes. A generator must handle the running total plus the largest starting surge that could occur at the same time, which is why two homes with the same running total can need different sizes.

Can a smaller generator run my whole house with load management?

Often, yes. Load-management modules pause heavy loads — a second AC unit, electric dryer, range, or EV charger — for short periods so they do not all run together. That can keep a home in a 16–22kW unit instead of moving to 24–26kW or larger. Ask for both options priced in writing: the larger unit, and the smaller unit with load management, so you can compare the total installed cost of each approach.

Is a bigger generator always better?

No. Oversizing raises the purchase and installation cost, can increase fuel use, and does not add protection if the loads are not there. Undersizing is also a problem — the unit can overload or fail to start AC under surge. The right size is the one that covers your running loads at about 80% of rated capacity, with a plan for starting surges. That is a calculation, not a guess from square footage alone.

How much does each size cost installed in Houston?

Installed totals overlap across sizes because gas, electrical, and site work drive much of the spread. As planning figures, smaller essentials systems tend toward the lower end of the Houston $9,000–$25,000 whole-house range, typical 16–22kW systems land in the middle, and 24–26kW+ or liquid-cooled systems land toward the upper end. See the full cost guide for the itemized breakdown behind those totals.

Should I trust a size recommendation from square footage alone?

Treat it as a starting point only. A recommendation with no load list, no discussion of AC tonnage, and no mention of electric cooking, drying, or charging is incomplete. Our audit of 22 TECL-verified Houston installers found the same gap in published information more broadly — for example, zero published their warranty terms — which is why a written load calculation and an itemized quote matter before you sign.

Want an itemized number for your home?

Answer the 60-Second Brief and get matched with a TECL-licensed local installer. Free, no obligation.

Start the 60-Second Brief